How window condensation works
Condensation forms when warm, moist indoor air meets glass colder than the air’s dew point — the temperature at which air can no longer hold all its water vapour and starts giving some back as liquid. The inside face of a window is usually the coldest surface in a heated room, so the glass is where the problem shows first — and it usually starts at the bottom edge and in the corners, because cooled air slides down the pane and the frame and spacer bar conduct heat out faster than the middle of the glass. How wet the windows get turns on two numbers: how much moisture is in the air, and how cold the glass gets. In a room at 20°C (68°F), the dew point is about 2°C (35°F) at 30% humidity, about 9°C (48°F) at 50%, and about 14°C (58°F) at 70% — so at 30% humidity only very cold surfaces get wet, while at 70% most windows, and some walls, collect water. The U.S. Environmental Protection Agency says to keep indoor humidity below 60%, ideally 30% to 50% — and moisture collecting on windows is its named sign that humidity is running too high. Everyday life adds the moisture: breathing alone adds about 3 pints of water vapour per person to a house’s air every day, before a single shower runs, and cooking, showering, laundry and houseplants add more. This checker works out which side of the glass is the problem for your windows, and names the fix.
To use it:
- Say where the water is. Wipe the glass with a finger: water on the room-facing glass wipes away from indoors; water between the panes cannot be wiped away at all; water on the outside face is on the other side of the glass. Where the water sits decides everything.
- Say which windows and which room. Every window means the whole house; one window means that window is different; a bathroom or kitchen window steams up first because showers and cooking add a lot of steam in a small room.
- Say when it appears. After cooking or showering means steam; mornings mean the coldest night air; all day means the room stays too wet; only in cold snaps means the glass only gets cold enough then.
- Say what the humidity is, what glazing the windows have, and whether curtains or blinds cover them at night. A cheap hygrometer gives you the humidity number; single glazing gets far colder than double; drawn curtains trap cold air against the glass.
- Say what adds moisture, whether any damage is showing, and how old the windows are. Laundry dried indoors, a humidifier and cooking without an extractor all add water to the air; mould, peeling paint, rotting wood or stains mean the water has already done damage; windows over 20 years old are likely to have tired seals.
What makes this checker different
The pages that rank for this search are guides — long lists of nineteen ways to stop condensation, and explainers that all say the same thing: lower the humidity, ventilate more, wipe the glass. That is the right general advice, but it is not the answer for your windows. Water on the outside face needs no fix at all, water between the panes needs a glazier and no amount of ventilating will help, and water on the inside face has three different causes — too much moisture, glass that is too cold, or curtains trapping cold air against the glass — each with a different fix. There is no free, standalone checker that takes where the water is, which windows, which room, when it appears, the indoor humidity, the glazing, the curtains, the moisture sources, any damage and the age of the windows, and turns them into a cause, a fix plan and a target humidity for your exact windows. This page is that answer: ten questions, an instant cause, the first fix named, and the dew-point figures that show why the fix works. It is a self-assessment, so it says plainly what it cannot know: it cannot measure your humidity, feel your glass, or see whether a seal has failed, and where the answer depends on a detail it does not ask about — whether water appears with wind-driven rain, for example — it says so instead of guessing.
When is this the right check?
At the first cold snap — run the checker when the windows steam up for the first time in autumn, because the humidity target and the curtain habit are decided before the damage starts. After a shower or a big cook — because water that clears in a few hours is normal, and water that lasts all day is not, and the checker tells you which one you have. When mould, peeling paint or stains appear — because the water has already done damage and needs treating, not just wiping. Before you buy a dehumidifier — because a dehumidifier is the wrong answer for a failed seal or for curtains trapping cold air, and the checker tells you whether humidity is even the cause. And when one window mists between the panes — because that is a failed seal, and only a glazier can fix it.
Honest limitations
A self-assessment, not a surveyor’s report
This checker cannot measure your humidity, feel your glass, or see whether a seal has failed. It cannot check whether the frame is rotting behind the paint, or whether water is coming in around the frame. If you are unsure, get a window professional in — do not guess.
Humidity is a guess without a hygrometer
The dew point turns on your humidity number, and without a hygrometer you are guessing: the same window can be dry at 30% humidity and streaming at 70%. A cheap hygrometer costs less than a bottle of mould cleaner and makes the checker’s answer far more useful.
Between the panes needs a glazier’s eyes
Water between the panes means the seal has failed, but only a glazier can say whether the frame is worth keeping or the whole window should go. Get a quote for the sealed glass unit alone first — it is usually far cheaper than a whole new window.
A leak is not condensation
This checker is about condensation — water that comes out of your own indoor air. Water that appears with wind-driven rain, soft trim, or water entering around the frame is a leak, and it needs a window professional, not a dehumidifier or drier air.
Mould needs professional help at scale
A few spots of mould can be cleaned once the moisture is under control. If mould covers a large area, or anyone in the home has breathing problems, get professional help rather than cleaning it yourself — and fix the moisture first, or it will come back.
Figures from official sources, dated November 2026
The figures here are the U.S. Environmental Protection Agency’s 30–50% humidity range and dew-point figures from the Magnus formula for a room at 20°C (68°F), as they read in November 2026. Guidance changes: recheck with your window’s maker if anything about your windows changes.