Is it cheaper to leave the heating on or turn it off?

Guides all give the same static answer — "turn it down". This calculator works it out for your house: your fuel price, your system, your insulation, your hours away — and shows both options side by side, per day and per season. Free, in your browser, nothing uploads.

  • Both options priced side by side, per day and per season
  • Freeze floor at 13°C — never recommends a risky setback
  • Heat-pump recovery penalty built in
  • Free, no account, nothing uploads
Is it cheaper to leave the heating on or turn it off? Compare both options for your house in seconds.

Compare the two options for your house

Try a preset:
0 of 9 answered
$

Your result

Answer the questions Your verdict appears here as you answer.
Recommended action

Fill in the temperatures above and the recommended action will appear here.

Side by side

OptionHeat a dayFuel a dayCost a dayCost a season

Fill in the temperatures and the side-by-side comparison will appear here.

Blockers

Things that do not fit

Things to check

Still to confirm

What to do next

    Your result summary

    
              

    Fill in the comfort temperature — the comparison updates live.

    Privacy you can verify, not just trust

    Comparing heating costs by uploading your home details to a website would be backwards — the check should never be the leak. This one can't: your answers are compared in your browser, and they never leave the device — the only third-party requests are the site's own analytics, which count page views. Don't take our word for it:

    New cross-origin requests during use: 0
    1. Press F12 to open developer tools, then the Network tab.
    2. Change a temperature above. Watch: apart from the site's analytics, nothing new is requested — no uploads, and no data ever leaves your device.
    3. Extra credit: disconnect your internet after this page loads — the calculator still works.

    How the heating-on-or-off comparison works

    The rule is the gap, not the habit. A web page cannot feel your house — it has no thermometer, no thermostat and no meter on your boiler — so it works from the numbers you enter. A house loses heat in proportion to the gap between inside and outside, so the energy used is proportional to that gap times the hours it is held. Leaving the heat on all day holds the full gap for 24 hours; turning it down while you are away holds a smaller gap for those hours, then reheats. The reheat takes about as much energy as was saved while the house cooled — the saving comes from the hours the house sat at the smaller gap, not from magic. That is why the US Department of Energy puts a 7–10°F setback for 8 hours a day at up to 10% off a year's heating, and why the Energy Saving Trust says a boiler left on all the time uses more energy and costs more than one that comes on only when needed. This calculator runs that model — the degree-hour model — on your numbers: your fuel price, your system, your insulation, your comfort and setback temperatures, your hours away, the outdoor temperature and the season length — and prices both options side by side.

    To use it:

    1. Pick your country and heating system. United States, United Kingdom, Germany, Canada or Australia; gas boiler, heat pump, electric heaters or oil boiler. The country sets your currency and the default fuel price — the US default is the EIA winter average, the UK default is the Ofgem price cap — and the system changes the maths, because a heat pump moves heat instead of making it.
    2. Say how well insulated your home is. Well insulated, average or draughty. Insulation decides how fast heat escapes — a draughty house loses heat fast, so the gap between the two options is bigger, and insulation would save more than either option.
    3. Enter the comfort and setback temperatures. Comfort is the temperature you want when you are home, usually 20°C (68°F); setback is the lower temperature while you are away, usually 15°C (59°F). The setback must be lower than comfort — and never below 13°C (55°F) while it is freezing outside, or the pipes can freeze.
    4. Say how many hours a day you are away, and the outdoor temperature. 8 hours is a workday; 16 or more is a weekend away. The outdoor temperature is the daytime average for your area in winter — 5°C (41°F) is a mild-winter example. The longer you are away, the more the setback pays.
    5. Check the fuel price, and the season length. The default price comes from your country and system — edit it to match your bill and the answer gets sharper. The season length, about 150 days for a typical winter, multiplies the daily saving into a season figure.
    6. Read the verdict and the side-by-side table. The calculator gives one verdict — turn it down, leave it on low, too close to call, or do not turn it that low — plus the cost of each option per day and per season, the saving, and the checks: the heat-pump recovery penalty, the damp watch, the freeze floor and the cross-check against the Department of Energy rule.

    The scenarios at a glance

    ScenarioCheaper optionWhy
    Workday away 8h, gas boiler, 20°C to 15°CTurn it downAbout 11% cheaper — the house sits at the smaller gap for 8 hours
    Overnight, gas boiler, timerTurn it downThe Department of Energy rule: 7–10°F for 8 hours saves up to 10% a year
    Weekend away 48h, gas boilerTurn it down to 13–15°CA long absence gives the setback a long time to pay off
    Heat pump, deep setback of 6°C or moreLeave it on lowThe hard recovery eats the saving — often with backup heat
    Heat pump, shallow setback of 1–2°CTurn it down a littleShallow enough that the pump recovers without backup heat
    Freezing weather, setback below 13°CLeave it on lowPipes can freeze and burst below 13°C (55°F) — no saving is worth that
    Well-insulated home, either optionToo close to callHeat escapes slowly, so the difference between the two options is small
    Away for 1–2 hours onlyLeave it as isToo short for a setback to pay — the house barely cools

    What makes this calculator different

    The pages that rank for this search are guides — Kiplinger, Scoop HVAC, Raymond Plumbing and a handful of newer guides that all give the same static answer, "turn it down", and leave you to work out what it means for your house, your fuel price and your system. None of them prices the two options for your numbers, and none of them names the exceptions that change the answer: the heat pump that loses its saving to a hard recovery, the setback that drops below the freeze floor, the draughty house where the gap is twice as big. The closest interactive tools answer different questions — a space-heater cost calculator, a personal-heating savings calculator about blankets, a space-heater-versus-central-heat comparison. There is no free, standalone calculator that takes your country, system, fuel price, insulation, comfort and setback temperatures, hours away and outdoor temperature and prices "leave it on low all day" against "turn it down while away" side by side, per day and per season, with the freeze floor and the heat-pump penalty built in. This page is that answer: nine inputs, an instant verdict for your exact house, the blockers named, and the next steps.

    When is this the right check?

    When the heating bill arrives and you wonder whether leaving the heat on all day is the wasteful part of it — because the calculator puts a number on both options instead of a slogan. When you are setting a timer for the first time — because it tells you the setback temperature that actually saves money for your house. When you have a heat pump and the usual advice does not seem to work — because the calculator names the recovery penalty and shows you the shallow setback that does save. When you are going away for a weekend in freezing weather — because it refuses to recommend a setback below 13°C and says why. And when you are choosing between a smart thermostat and a timer — because the season figure tells you what the setback is worth over a whole winter.

    Honest limitations

    The money figures are estimates, not a bill

    The money figures are the calculator's own estimates, built from the degree-hour model and the fuel price you enter. Your bill depends on your tariff, your insulation, your heating system and the weather — a heat pump, for example, saves less from big setbacks than a gas boiler does. Edit the fuel price to match your bill and the answer gets sharper.

    The model is a simplification

    The degree-hour model treats heat loss as proportional to the inside–outside gap, which is the physics every heating guide agrees on — but it does not model thermal mass, solar gain, wind, or a boiler that cycles on and off. A house with heavy masonry cools and reheats more slowly than the model says; a sunny room gains free heat the model ignores.

    Insulation is three rough bands

    Well insulated, average and draughty are rough bands, not a survey of your house. The heat-loss figures behind them — 110, 180 and 280 watts per degree — are typical values for a family home, not measurements. If your house is unusually large, small, old or new, the daily cost will be off even when the percentage saving is about right.

    The freeze floor is a rule, not a guarantee

    13°C (55°F) is the usual floor for an empty house when it is freezing, but pipes in an uninsulated wall or an unheated garage can freeze above it, and a house with the heating off entirely can drop below it fast in a cold snap. If the forecast says well below freezing, keep the heat higher and leave cupboard doors open under sinks on outside walls.

    Heat-pump recovery is estimated

    The 15% recovery penalty for deep heat-pump setbacks is the calculator's own estimate, not a measured figure for your pump. Real recovery cost depends on the pump, the outdoor temperature and whether backup heat kicks in — check your installer's advice for your model.

    Rules from the DOE, Energy Saving Trust, EIA and Ofgem, dated November 2026

    The rules here are the US Department of Energy, Energy Saving Trust, US EIA and Ofgem guidance as it reads in November 2026: the 7–10°F setback saving up to 10% a year, the boiler-on-all-the-time warning, the EIA winter-average prices and the Ofgem price cap. Tariffs change: recheck the fuel price when your tariff changes.

    Frequently asked questions

    Is it cheaper to leave the heating on or turn it off?

    For most homes with a gas or oil boiler, it is cheaper to turn the heating down while you are away than to leave it on all day. A house loses heat in proportion to the gap between inside and outside, so holding a smaller gap for the hours you are away uses less energy — and the reheat takes about as much energy as was saved while the house cooled, so the saving comes from the hours the house sat at the smaller gap. The US Department of Energy puts a 7–10°F setback for 8 hours a day at up to 10% off a year's heating. This calculator works it out for your house: enter your fuel price, system, insulation and temperatures and it shows both options side by side, per day and per season.

    Is it cheaper to leave the heating on low all day?

    Usually not, if you have a gas or oil boiler. The Energy Saving Trust says keeping a boiler on all the time uses more energy and costs more than heating only when you need it — a house held warm all day loses heat all day, and a cooler house leaks less heat to the outdoors. The main exception is a heat pump, which works best running low and steady, and underfloor heating, which warms up slowly. In a very well insulated home the difference between the two approaches is smaller, because heat escapes slowly either way.

    Does turning the heat off damage the boiler or freeze the pipes?

    Turning the heat down does not damage a boiler, but turning it off completely in freezing weather can freeze the pipes — and a burst pipe costs far more than any saving. Keep an empty house at 13°C (55°F) or above when it is freezing outside, and leave cupboard doors open under sinks on outside walls so warm air reaches the pipes. This calculator refuses to recommend a setback below 13°C while it is freezing outside and says so plainly. A setback below 15°C for hours at a time can also let damp in, because warm, moist air condenses on cold walls and windows.

    What temperature should I leave the heating on when I am away?

    For a workday away, set it back to about 15°C (59°F) from a comfort temperature of 20°C (68°F) — a 5°C drop for 8 hours is the pattern the US Department of Energy's 7–10°F guidance points to, and it saves up to 10% a year. For a weekend away, 13–15°C is the safe range. Never go below 13°C (55°F) while it is freezing outside. For a heat pump, set it back by only 1–2°C, because a deep setback forces the pump to work hard to recover and eats the saving.

    Is a heat pump different — should I leave it on all the time?

    Yes — a heat pump is the exception to the turn-it-down rule. Heat pumps work best running low and steady, because a big setback forces the pump to work hard (often with backup electric heat) to recover, and that recovery can cost more than the setback saved. This calculator applies a recovery penalty to deep heat-pump setbacks of 6°C or more and flags it. For a heat pump, set it back by only 1–2°C overnight or while you are away, and leave it steady the rest of the time.

    How much can a thermostat setback actually save?

    The US Department of Energy says turning the thermostat down 7–10°F for 8 hours a day can save up to 10% a year on heating — about 1% per degree of setback. For a typical workday pattern (20°C comfort, 15°C setback, 8 hours away, 5°C outside, average insulation) this calculator's degree-hour model gives about 11% — in the same range, which is what the physics predicts. The exact figure depends on your fuel price, your insulation and how long you are away: a draughty house and a long absence make the saving bigger, and a well-insulated house makes it smaller. The money figures here are the calculator's own estimates, built from the fuel price you enter.

    What about underfloor heating — on all day or timed?

    Underfloor heating warms up slowly, so it often works better running steadily on cold days rather than switching on and off — like a heat pump, it is an exception to the turn-it-down rule. A deep setback with underfloor heating means a long, slow recovery that can leave the house cold when you get home. If you have underfloor heating, use a small setback of 1–2°C, or leave it steady, and use this calculator's heat-pump setting as the closest match for the comparison.

    Does this calculator send my details anywhere?

    No. The comparison runs entirely in your browser — your country, temperatures, fuel price and insulation never leave your device, and the only third-party requests are the site's own analytics, which count page views. You can check with the privacy meter on this page, which counts new cross-origin requests while you use the calculator, or disconnect your internet after the page loads and keep using it.