Should you replace your tyres — or are they fine?

Enter the tread depth, the tyre age from the DOT code and any damage you can see — and get a verdict: replace now, replace soon, or keep driving. Entirely in your browser.

  • Verdict from your own measurements
  • Legal minimums for US, UK, DE, CA, AU
  • Age and damage counted, not just tread
  • Free, no account, nothing uploads

Check your tyres

Try a preset:
Damage you can see Tick everything that applies — a bulge or a cut can retire a tyre with deep tread.

Your result

Enter your tyres Your verdict appears here as you answer.
Your tyres, measured

Enter the tread depth, the tyre age, or tick any damage you can see, and your tyres will be measured here against the legal minimum and the safe replacement point.

Blockers

Things to check

Still to confirm

What to do next

    Your result summary

    
              

    Enter the tread depth, tyre age, or tick any damage — the verdict updates live.

    Privacy you can verify, not just trust

    Checking whether your tyres are safe by uploading your car's details to a website would be backwards — the check should never be the leak. This one can't: your measurements are checked with plain JavaScript on your device, and they never leave the device — the only third-party requests are the site's own analytics, which count page views. Don't take our word for it:

    New cross-origin requests during use: 0
    1. Press F12 to open developer tools, then the Network tab.
    2. Enter a number above. Watch: apart from the site's analytics, nothing new is requested — no uploads, and no data ever leaves your device.
    3. Extra credit: disconnect your internet after this page loads — the checker still works.

    How to check whether your tyres need replacing

    Three things retire a tyre: tread depth, age, and damage — and any one of them is enough on its own. A 3-year-old tyre with low tread needs replacing. A 9-year-old tyre with deep tread also needs replacing, because the rubber is old. And a tyre with a bulge in the sidewall needs replacing whatever the tread says. The pages that rank for this question are guides — AutoFixr, NeoTires, Carwiz, TireAgent — and they all explain the same three rules in words. None of them takes your measurements and gives you a verdict. This page does: enter the tread depth, the tyre age from the DOT code and any damage you can see, and it tells you whether to replace now, replace soon, or keep driving, against the legal minimum and the safe replacement point for your country.

    To use it:

    1. Measure the tread depth. Use a gauge in the main grooves, at the most worn spot — not the best spot. A new passenger-car tyre starts at about 8 mm. No gauge? Use the coin test: in the UK, push a 20p coin into a groove — if you can see the coin's outer band, the tread is at or below the 1.6 mm legal limit. In the US, a quarter works the same way: if you can see the top of Washington's head, the tread is at or below 4/32 in.
    2. Read the tyre age. Look for the DOT code on the sidewall. The last four digits are the week and year the tyre was made — 2621 means week 26 of 2021. If the code has only three digits, the tyre was made before 2000 and is long past its life.
    3. Look for damage. Run a hand over the sidewalls and look between the tread blocks: cracks, bulges, cuts, exposed cords, a puncture in the sidewall, or wear that is heavier on one edge or on the shoulders. Tick anything you find — a bulge or a cut can retire a tyre with deep tread.
    4. Pick the country and the tyre type. The legal minimum is 1.6 mm in the UK, Germany and most of Canada, 2/32 in (1.6 mm) in the US and 1.5 mm in Australia. Winter tyres get a higher replacement point — 4 mm — because snow grip depends on tread depth.
    5. Read the verdict, then the numbers. The verdict is worked out from the worst of the three rules: tread, age and damage. The numbers table shows your tread against the legal minimum and the safe replacement point, and how much of a new tyre's tread you have left.

    What makes this checker different

    The pages that rank for this question today are guides and tyre-shop articles — AutoFixr, NeoTires, Carwiz, TireAgent, Pickups Plus Cars — and all of them explain the thresholds in words, with tables you have to compare against your own measurements. None of them runs your numbers. The calculators that do exist answer a different question: what size tyre fits your car, or what the speed rating means. None of them judges your tyres: none combines tread depth with age and damage, none applies the right legal minimum for your country, none uses a different replacement point for winter tyres, and none tells you what to do next when the answer is "replace soon". This page does all four, for five countries, and it says plainly where every figure comes from: GOV.UK / DVSA, NHTSA, AAA, Michelin, NRMA and RACV — all as published in November 2026.

    When is this the right check?

    Whenever you are unsure about a set of tyres — before a long trip, before winter, when a service mentions wear, when you buy a used car, or when you notice a crack, a bulge or a vibration. It is also the right check when a tyre fitter tells you the tyres are "getting low": run your own numbers through it before you pay. It is not a substitute for a professional inspection: if the verdict is "replace now" because of a bulge or exposed cords, do not drive on the tyre at motorway speed to get it checked — fit the spare or call for recovery.

    Honest limitations

    General information, not safety advice

    This checker applies published figures to the numbers you enter. It cannot see your tyres, and it cannot advise on a specific vehicle. If in doubt, have a tyre fitter inspect the tyres before you drive.

    Your tread reading is the weak point

    The verdict hangs on the tread depth you enter, and a coin test is only a rough guide. Measure in the main grooves at the most worn spot — a reading taken at the best spot can hide a tyre that is already illegal.

    No mileage or remaining-life estimate

    The checker does not guess how many kilometres your tyres have left. Wear rates vary too much by car, driving style, roads and inflation to put an honest number on it — the verdict is about safety now, not a forecast.

    The spare is not in the check

    The check covers the four tyres on the ground. Michelin applies the same 10-year limit to the spare, and suggests its pressure gets a check annually, against monthly for the four tyres on the ground.

    Pressures are not in the maths

    Under-inflation wears the shoulders and over-inflation wears the centre, and both shorten a tyre's life — but the checker cannot know your pressures. Check them monthly, including the spare, against the figure on the driver's door jamb or the fuel cap.

    Figures dated November 2026

    The figures quoted here are as published in November 2026: legal minimums 1.6 mm (UK, Germany, US 2/32 in, Canada most provinces) and 1.5 mm (Australia, NRMA / RACV); AAA replace at 4/32 in (3.2 mm); winter tyres at 4 mm; NHTSA inspect from 6 years, replace by 10 years; Michelin inspect annually from 5 years, replace by 10 years. Limits and guidance change, so re-check the sources if you read this later.

    Frequently asked questions

    What is the legal minimum tyre tread depth?

    It is 1.6 mm in the UK, Germany and most of Canada, 2/32 in (1.6 mm) in the US, and 1.5 mm in Australia (NRMA / RACV). The legal number is not the safe number, though: AAA recommends replacing at 4/32 in (3.2 mm), because its testing found tyres worn to 4/32 in take an extra 87 feet to stop on wet pavement at highway speed. Enter your tread depth in the checker above and it compares it with both the legal minimum and the safe replacement point for your country.

    How old is too old for tyres?

    NHTSA says to have tyres inspected at every service visit once they are 6 years old, and to replace them by 10 years regardless of how much tread is left. Michelin says the same: inspect annually after 5 years, replace by 10 years even if the tread still looks good. Rubber hardens and cracks with age, so a tyre with deep tread can still be unsafe if it is old. Read the age from the DOT code on the sidewall — the last four digits are the week and year of manufacture, so 2621 means week 26 of 2021.

    How do I measure tyre tread depth without a gauge?

    Use the coin test. In the UK, push a 20p coin into a main groove: if you can see the coin's outer band, the tread is at or below the 1.6 mm legal limit. In the US, use a quarter the same way — if you can see the top of Washington's head, the tread is at or below 4/32 in. A gauge is more accurate and costs a few pounds or dollars; the checker takes a number in millimetres, and shows the 32nds equivalent for US drivers.

    When should winter tyres be replaced?

    Winter tyres should be replaced at 4 mm of tread (5–6/32 in), well above the legal minimum, because snow grip depends on tread depth to pack snow into the grooves. Below 4 mm a winter tyre performs about like a worn all-season tyre. The checker uses 4 mm as the safe replacement point when you select winter tyres, instead of the 3.2 mm point it uses for summer and all-season tyres.

    Can I drive on a tyre with a bulge or a cut in the sidewall?

    No — a bulge means the tyre's structure is damaged inside and it can blow out without warning, and a cut deep enough to show cords means the casing is exposed. A puncture in the sidewall or shoulder cannot be repaired safely either; repairs only hold in the tread area. Tick any of these in the checker and the verdict is replace now, with the advice to fit the spare or call for recovery rather than driving on it.

    Does uneven tyre wear mean I need new tyres?

    Uneven wear is a warning, not a verdict on its own. Wear on the shoulders usually means under-inflation, wear in the centre means over-inflation, and wear on one edge usually means the wheel alignment is out. The tyre may still need replacing, but if you do not fix the cause, the new tyres will wear the same way. The checker flags uneven wear and tells you to get the alignment and pressures checked when the tyres are replaced.

    Does this checker upload my measurements?

    No. The check runs entirely in your browser with plain JavaScript, and your measurements never leave your device — the only third-party requests are the site's own analytics, which count page views. You can verify it with the network-request counter in the privacy section below the checker. This checker is general information, not safety advice for a specific vehicle: it applies the published figures as they read in November 2026 to the numbers you enter. If in doubt, have a tyre fitter inspect the tyres before you drive.