How the cracked-windscreen rule works
The MOT windscreen rule is a size rule, and it is written in the DVSA MOT inspection manual (section 3.2, Visibility) as it reads in November 2026. The windscreen is split into two zones. Zone A is a 290 mm-wide vertical strip centred on the steering wheel, within the area the wipers sweep — your direct line of sight while driving. A single area of damage more than 10 mm across in Zone A is a major defect — an MOT fail — when it significantly affects your view of the road. Zone B is the rest of the wiper-swept area, and the limit there is 40 mm: damage bigger than that fails. Damage outside the area the wipers sweep is not assessed for the MOT at all. On top of the MOT rule sits the driving rule: the Highway Code says windscreens must be kept clean and free from obstructions to vision, and driving a vehicle in a dangerous condition can bring a fine of up to £2,500, 3 penalty points and a possible driving ban. So a crack that blocks your view means do not drive, whatever the MOT would say about its size.
To use it:
- Pick the damage type. A chip is a small pit where a stone struck the glass; a crack is a line running across it; a star break or bullseye is a chip with cracks radiating from it. The type changes whether it can be repaired: chips up to about 25 mm can usually be repaired, cracks up to about 75 mm sometimes can, and a star break spreads more easily than a plain chip.
- Enter the size in millimetres. Measure the longest line of the damage with a ruler. Without one, compare it with a coin: a 5p coin is about 18 mm across, a £1 coin about 23 mm, a £2 coin about 28 mm. The size is what the MOT rule turns on — 10 mm in Zone A, 40 mm in Zone B.
- Say where it sits. Zone A is the 290 mm strip in front of the steering wheel, as far as the wipers reach. Zone B is the rest of the area the wipers sweep. Outside the swept area — usually a corner or the very edge — the MOT does not assess the damage, but it still must not obstruct your view.
- Say whether it blocks your view. Sit in the driver’s seat and look through it. If the damage sits in your line of sight to the road ahead, it blocks your view — and that alone means do not drive, whatever the size.
- Say whether it is near the edge. Within about 7 cm of the edge of the glass usually means a replacement, whatever the size — the edge is where the windscreen is bonded to the car, and a repair there does not hold.
- Say whether it is spreading. Heat and cold, potholes and slammed doors all make cracks grow. Mark the ends with a pen or take a photo, then check again in a few days — if it has grown, book a repair straight away.
- Say whether there is more than one damaged area. A tester can judge several small areas together, and several chips usually mean a replacement rather than a repair.
What makes this checker different
The pages that rank for this search are guides — the RAC, the AA, Protyre, Compare the Market and windscreen companies explaining the 10 mm and 40 mm limits in words. There is no free, standalone checker that takes your damage’s size and position and gives you a verdict: MOT fail or pass, can you drive or not, repair or replace — with the coin-size guide for measuring without a ruler, the spreading and edge questions built in, and the next steps named. This page is that answer: seven questions, an instant verdict for your damage, the exact limit the MOT applies, the blockers named, and the next steps. It is a self-assessment, so it says plainly what it cannot know: a web page cannot measure your windscreen, a tester has to judge whether damage significantly affects your view, and only a windscreen specialist can say whether your glass can be repaired.
When is this the right check?
When a stone has just hit your windscreen and you need to know whether you can drive home. When your MOT is coming up and you want to know whether the chip will fail it — fix it before the test, not after. When a chip has been there a while and you are not sure whether it has grown into something that fails. And whenever a guide gives you the 10 mm and 40 mm limits without telling you which zone your damage is in: the number is meaningless until you know whose limit it is.
Honest limitations
A self-assessment, not legal advice
This checker cannot measure your windscreen or see whether it blocks your view. Check your local rules and a qualified windscreen specialist before you drive, especially if the damage is anywhere near your line of sight.
The tester judges the view, not the ruler
In Zone A the MOT tester must judge whether the damage significantly affects your view of the road — a small chip that does not can still pass, but the tester decides, not this checker. This checker applies the size limit and says so.
Repair or replace is the specialist’s call
The repair limits here — chips up to about 25 mm, cracks up to about 75 mm, nothing within 7 cm of the edge — are the usual figures windscreen specialists work to. The final call is theirs, once they have seen the glass.
UK rules, stated plainly
The limits here are the UK DVSA MOT rules. In the United States the rules differ by state — some fail a safety inspection for a crack in the driver’s view, others have no inspection at all. If you are outside the UK, check your local rules instead of relying on these limits.
A crack that passes today can fail next week
Damage spreads. Heat, cold, a pothole or a slammed door can turn a chip that passes the MOT into a crack that fails it. A verdict from this checker is a verdict for the damage as it is now — check it again if it grows.
Rules from the DVSA manual, dated November 2026
The limits here are the DVSA MOT inspection manual (section 3.2) and the Highway Code as they read in November 2026. Rules change: confirm the exact position with your MOT tester, and the exact insurance position with your insurer, before you drive.